Subject	Re: Structural integrity and handling if headlight basket...
Posted by	Hoov100 on December 19, 2010 at 4:06 PM
	This message has been viewed 293 times.
In Reply To	Structural integrity and handling if headlight basket... posted by andygp on December 19, 2010 at 02:05 PM
Message	From what I have seen, everything in front of the core support is all crumple zone and everything from the core support to the motor is structural support, even though most front end wrecks like to completely take out everything from the motor forward. This car tboned the front axle of an expedition at 45mph and pushed the radiator into the water pump pulley.
Follow Ups	Structural integrity and handling if headlight basket... - andygp 14:05:14 12/19/10 Be gentle with me.. (n/m) - andygp 14:19:59 12/19/10 That's what she said. - BigTDogg (MA) 08:15:51 12/20/10 Ha ha lol.. - andygp 13:26:47 12/20/10 single tilt front piece? - KasbeKZ(VA) 14:21:30 12/19/10 yes sir. (n/m) - andygp 14:23:54 12/19/10 Re: Structural integrity and handling if headlight basket... - Hoov100 16:06:23 12/19/10 your fraim rails will twist witout the front end. - Timmay 18:19:49 12/19/10 This is the tilt front hinge assembley - as you can see... - andygp 07:20:35 12/20/10 Did you really cut the frontend of the car off in that pic? (n/m) - Crim 18:43:07 12/19/10 Not yet - hence the question Powis.. - andygp 06:32:13 12/20/10 I would expect the car to be a floppy mess. (n/m) - Bernie (NoVA) 22:36:10 12/19/10 I thought the same, but it seems that some folks - andygp 07:30:18 12/20/10 You'll need something to square the top. (n/m) - Bernie (NoVA) 10:41:57 12/20/10 Bernie, I will probably make something like this... - andygp 12:51:36 12/21/10 Keep the frame rails, cross member, maybe weld in the bumper - FuerGrissa 02:42:52 12/20/10 what kinda car is that?? (n/m) - blackomega 07:51:34 12/20/10 evo-viii (n/m) - Bernie (NoVA) 08:38:10 12/20/10 i thought it was evo from the fenders - blackomega 11:35:22 12/20/10 the picture's URL give it away. (n/m) - Halo TTZ 17:13:40 12/20/10
Post a Followup	You cannot reply to this message because you are not logged in.