Subject	thanks
Posted by	KasbeKZ(VA) on December 18, 2010 at 12:53 AM
	This message has been viewed 90 times.
In Reply To	yes posted by vorpalZ on December 17, 2010 at 10:07 PM
Message	so i guess the placement of the loom between the PTU and the split from the main harness is easy enough to figure out? just tie it out of the way over in front of the left fender well?
Follow Ups	can't find any PTU relocation pictures - KasbeKZ(VA) 21:27:49 12/17/10 . - ZiNnYc 21:39:28 12/17/10 thanks. i'm surprised i didn't see that in my search (n/m) - KasbeKZ(VA) 22:22:05 12/17/10 yes - vorpalZ 22:07:36 12/17/10 IIRC, you remove the upper brace for the rad - CoHPhasor 22:40:24 12/17/10 correct... fourth pic (n/m) - vorpalZ 22:51:03 12/17/10 Ditto. - scoTTinald (BC) 23:01:21 12/17/10 thanks - KasbeKZ(VA) 00:53:24 12/18/10 route the PTU wiring under the intake soft hoses - vorpalZ 08:41:56 12/18/10 Yup. That's where mine was at. - zfreak(Dallas) 10:48:00 12/18/10 Under nose panel. - jschrauwen 06:10:16 12/18/10 Good idea. Doesn't mess up the view... - 240Z FeO2 12:25:39 12/18/10 Not a great pic, but where mine lives... - Stadsport (PHX) 15:48:13 12/18/10 i like that place. how did you attach it? - KasbeKZ(VA) 16:08:57 12/18/10 I used one of the bolt holes for the relay box iirc - Stadsport (PHX) 16:12:52 12/18/10 FYI - Bernie (NoVA) 16:22:50 12/18/10 Re: FYI - Stadsport (PHX) 19:08:59 12/18/10 Carry on. (n/m) - Bernie (NoVA) 11:38:46 12/19/10 Mine too, easier to get timing readings (n/m) - BigTDogg (MA) 09:35:11 12/19/10 Doe this count? - intel 18:12:25 12/18/10 Bad place for the transistor pack - Spddracer 18:21:54 12/18/10 Eh will have to see I guess. - intel 19:49:45 12/18/10 eh I dunno - aliaZ 08:47:21 12/19/10 The old ones did have fins, but they also failed - BigTDogg (MA) 09:36:11 12/19/10 You can fix the old ones, Simple cold solder joint. (n/m) - Spddracer 14:01:11 12/19/10 Yep - ArubaDave 14:09:20 12/19/10 not just in the engine bay, but in the hottest part - vorpalZ 10:07:21 12/19/10 Very cool! Do you have a copy of this picture with - Jim (Selin Design) 12:10:24 12/20/10 Sorry, no - vorpalZ 12:36:48 12/20/10
Post a Followup	You cannot reply to this message because you are not logged in.