Subject	2nd -> more power = larger clearances
Posted by	LitlElvis on December 10, 2010 at 4:49 PM
	This message has been viewed 114 times.
In Reply To	the things you learned at UTI is for stock rebuilds posted by aliaZ on December 10, 2010 at 04:37 PM
Message	I wouldn't say so much on bearings but especially with respect to piston ring gaps and piston to wall clearances.
Follow Ups	Is tighter always better? - ZXoltan 16:00:58 12/10/10 The only reason I can think of tightening up the clearances - JonnyZ(SoCal) 16:28:02 12/10/10 the things you learned at UTI is for stock rebuilds - aliaZ 16:37:20 12/10/10 2nd -> more power = larger clearances - LitlElvis 16:49:53 12/10/10 applies to engine bearings as well IMHO - aliaZ 18:17:15 12/10/10 Yes, I've always followed ~0.001" per inch of journal dia - LitlElvis 18:40:33 12/10/10 according to my sig pic - Adam (NoVA) 16:53:49 12/10/10 Lol! (n/m) - JonnyZ(SoCal) 17:06:11 12/10/10 appropriate answer (n/m) - WickedZX (NoVA) 17:19:03 12/10/10 thread hijack - Adam (NoVA) 17:21:55 12/10/10 My 240 is long gone. - WickedZX (NoVA) 17:47:11 12/10/10 update your profile :) (n/m) - Adam (NoVA) 09:55:50 12/11/10 not necessarily (n/m) - aliaZ 18:19:57 12/10/10 Always stay within recommended specs. "Tighten up", - zellamay 18:24:10 12/10/10 "always" is incorrect in my opinion - aliaZ 18:35:52 12/10/10 Re: Is tighter always better? - ttz'in (NorCal) 22:46:50 12/10/10
Post a Followup	You cannot reply to this message because you are not logged in.