Subject	why do you say that?
Posted by	aliaZ on December 10, 2010 at 7:08 AM
	This message has been viewed 54 times.
In Reply To	Time to calibrate your torque wrench. (n/m) posted by Draker (Eugene, OR) on December 09, 2010 at 10:04 PM
Message	Calibrated or not, an M6 bolt will still break if torqued to 15 ft/lbs
Follow Ups	broke another bolt last night - Shiers69 14:19:07 12/09/10 Picture? (n/m) - ZiNnYc 14:23:28 12/09/10 never seen a broken bolt before? (n/m) - Shiers69 14:27:31 12/09/10 lmao. of the FSM with the bad value. (n/m) - ZiNnYc 14:28:25 12/09/10 this isn't the first time i've found a discrepancy - Shiers69 14:39:11 12/09/10 yeah, when i did my first rebuild i found out the rod caps - Halo TTZ 22:20:18 12/09/10 MT Upper Cover bolt torques from each FSM - Shiers69 14:24:49 12/09/10 Same I got after looking through them - Spddracer 15:26:44 12/09/10 everyone has to learn somehow (n/m) - Shiers69 15:48:58 12/09/10 No doubt. - Spddracer 17:23:26 12/09/10 Just don't use the rod bolt spec that's wrong..... (n/m) - Spddracer 15:27:31 12/09/10 Time to calibrate your torque wrench. (n/m) - Draker (Eugene, OR) 22:04:18 12/09/10 why do you say that? - aliaZ 07:08:23 12/10/10
Post a Followup	You cannot reply to this message because you are not logged in.