Subject	Maybe mine wasn't done correctly but it stripped every piece
Posted by	JonnyZ(SoCal) on December 06, 2010 at 6:37 PM
	This message has been viewed 90 times.
In Reply To	No, but it will probably harm the finish posted by thumper on December 06, 2010 at 06:30 PM
Message	of paint off of my plenum! Some shops use a hot tank jet where they spray high pressure chemicals into it instead of dipping it. This was done on my supra and works just as well, it might not get on your powder coat!
Follow Ups	Metal shavings in upper intake plenum - MY3ZTT 13:18:20 12/06/10 Yes, find a local machine/auto shop and hot tank it. (n/m) - BigTDogg (MA) 13:26:30 12/06/10 2nd. I hot tanked my plenum, it only cost 20$ for a lot of - JonnyZ(SoCal) 15:27:37 12/06/10 how did it turn out? - inf 20:27:27 12/06/10 It didn't melt! It turned out really good, I'll see if I can - JonnyZ(SoCal) 21:24:50 12/06/10 Here's some pix... - JonnyZ(SoCal) 21:50:29 12/06/10 Incorrect. I worked in a machine shop, the hot tank - J_Wright 23:47:06 12/06/10 If you washed it out with water, used compressed air... - Zinn2win 14:52:13 12/06/10 Uhm, no? - Dallas DamonZ 15:04:18 12/06/10 Damon is right-- - Keaner 15:32:39 12/06/10 Leftover glass bead will destroy your engine faster - ZXoltan 16:43:56 12/06/10 He didn't say anything about glass bead! Just metal 'dust'. (n/m) - Zinn2win 20:34:53 12/06/10 Correct, and you mentioned "sandblasting stuff" - ZXoltan 06:19:59 12/07/10 horribly incorrect advice - aliaZ 16:49:42 12/06/10 Ultrasonic tank would be the best (n/m) - thumper 16:13:29 12/06/10 Will hot tanking remove powder coating? - MY3ZTT 18:19:25 12/06/10 No, but it will probably harm the finish - thumper 18:30:41 12/06/10 Maybe mine wasn't done correctly but it stripped every piece - JonnyZ(SoCal) 18:37:57 12/06/10 He said his was powdercoated, not painted (n/m) - thumper 22:21:07 12/06/10 I meant poweder coat!!! (n/m) - JonnyZ(SoCal) 22:24:44 12/06/10 Powder coat is paint ;) (n/m) - Spddracer 22:35:56 12/06/10 Technically correct :) (n/m) - thumper 00:03:10 12/07/10
Post a Followup	You cannot reply to this message because you are not logged in.