TwinTurbo.NET: Nissan 300ZX forum - Its was a piece of crap
People Seeking Info
 
   


     
Subject Its was a piece of crap
     
Posted by collegeboy on November 21, 2010 at 10:10 PM
  This message has been viewed 561 times.
     
In Reply To I was just thinking about the Crower Crankshaft posted by induetime on November 21, 2010 at 07:54 PM
     
Message I wouldn't recommend Castillo for anything.

Thanks,
Mike
1991 Black 3.0 Twin Turbo

HREF="http://www.mototuneusa.com/break_in_secrets.htm">
La-Z-
Link

^^Hard engine break in method^^
HREF="http://efcdcccd.facebook.com/profile.php?
id=196002800">La-Z-
Link

^^MY FACEBOOK...CHECK IT OUT^^

Collegeboy designed and produced 7 sided locking titanium lug
nuts $340
shipped. 150,000 psi tensile strength, and
heat treated. E-mail me at michaelkih@hotmail.com if
interested.
SRC="http://i658.photobucket.com/albums/uu302/michaelkih/
CIMG3761
.jpg" width=500>

---Me: You bought a Porsche?
---sfpearl300z: lol, no no, I have a decent sized penis so no
need for
that.
"felt wierd fingering my exhuast for 1hr with no results :(" -
zboost
"lmao, i know, theres more drama and favoritism on tt.net
than a middle
school girls locker room" - sfpearl300z
"I think I'll pass on giving my car a handjob" - joel(PA)
"I did plug the holes, But I did it by taping over them a lot, I
didnt think
that maybe HOT air is comming through
there, And it melted the tape, damnit im an ass." - DC 21

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.