Subject	Are you pressurizing them from the threaded end?
Posted by	LitlElvis on November 20, 2010 at 3:14 PM
	This message has been viewed 71 times.
In Reply To	PCV valve question posted by zhundred3x on November 20, 2010 at 02:06 PM
Message	You might hear them leak a bit, they're not a perfect seal, but they won't allow a huge volume of air to pass. My guess is an older valve has built up carbon and oil in it that conforms to make a better seal.
Follow Ups	PCV valve question - zhundred3x 14:06:04 11/20/10 Are you pressurizing them from the threaded end? - LitlElvis 15:14:37 11/20/10 Yes, I'm pressurizing them from the threaded end. - zhundred3x 15:29:29 11/20/10 Just ran into the same exact thing. I had some older - ThunderZ 22:01:12 11/20/10 how did u pressurize them? (n/m) - Nis300owner 23:04:25 11/20/10 Pretty much the same way as zhundred3x except I clamped - ThunderZ 12:26:11 11/21/10 I just got a new set from Nissan - ZXoltan 07:50:36 11/21/10 Here's a pic of what I did. I turned the pressure regulator - zhundred3x 11:29:30 11/21/10 I think you're worrying too much about it - LitlElvis 12:05:17 11/21/10 At 5 psi they leak CONSIDERABLY more than the typical boost - zhundred3x 12:33:31 11/21/10
Post a Followup	You cannot reply to this message because you are not logged in.