Subject	They are not supposed to be parallel to the ground @ WOT (n/m)
Posted by	Bernie (NoVA) on November 05, 2010 at 12:26 AM
	This message has been viewed 46 times.
In Reply To	My 91 has the WOT adjustment bolt too, noticed my posted by CoHPhasor on November 04, 2010 at 09:18 PM
Message
Follow Ups	Whats the diff between these two throttle linkages ? - xteam300tt 19:38:20 11/04/10 I just found a post that said there was a difference in - xteam300tt 20:12:38 11/04/10 I have a few of these for spares/cores, I have seen - whip 21:02:22 11/04/10 My 91 has the WOT adjustment bolt too, noticed my - CoHPhasor 21:18:46 11/04/10 Re: My 91 has the WOT adjustment bolt too, noticed my - whip 21:21:32 11/04/10 Could you / should you adjust them to be parallel ? - xteam300tt 21:29:24 11/04/10 No. Correct TB angle is the issue. Removing the bolt doesn' - Bernie (NoVA) 10:25:14 11/05/10 They are not supposed to be parallel to the ground @ WOT (n/m) - Bernie (NoVA) 00:26:05 11/05/10 Didn't think so, hoses are angled after all. - CoHPhasor 23:41:55 11/05/10 '90 USDM W/ nut & bolt here as well. (n/m) - ttz'in (NorCal) 21:23:47 11/04/10 Later model years eliminated the screw. (n/m) - Bernie (NoVA) 23:59:50 11/04/10 True. I replaced my plenum since it had a couple - flashstar 20:58:34 11/05/10
Post a Followup	You cannot reply to this message because you are not logged in.