Subject	Sorry i should have said...no codes....55 (n/m)
Posted by	RonZ300 on November 01, 2010 at 1:22 PM
	This message has been viewed 72 times.
In Reply To	have you checked your ECU for codes? posted by Halo TTZ on November 01, 2010 at 12:56 PM
Message
Follow Ups	2nd CAS on the 96 in transmission bell housing???? - RonZ300 00:09:14 11/01/10 Just checked my FSM...for OBD2 only, not engine control. (n/m) - RonZ300 00:32:00 11/01/10 I have one of those lying around. (n/m) - dansz 01:59:06 11/01/10 You know that sounds silly, Cam angle sensor in tranny?? lol (n/m) - Z32TT-R 02:20:05 11/01/10 i see no "cam", just "crank". (n/m) - Halo TTZ 10:33:45 11/01/10 that is used to detect misfire (n/m) - aliaZ 06:28:02 11/01/10 . - ZiNnYc 07:44:17 11/01/10 Any idea what would happen if the sensor was no good? (n/m) - RonZ300 09:03:19 11/01/10 CEL and I believe the idle would be all over the place. (n/m) - Bernie (NoVA) 09:40:30 11/01/10 Well i have no CEL but my idle is anything but smooth.... - RonZ300 12:47:18 11/01/10 have you checked your ECU for codes? - Halo TTZ 12:56:10 11/01/10 Sorry i should have said...no codes....55 (n/m) - RonZ300 13:22:57 11/01/10 have you done a power balance test? - aliaZ 13:35:21 11/01/10 Yup...and yup and no boost/vacuum leaks (n/m) - RonZ300 16:43:29 11/01/10 The last 96 we had with an idle issue. The 2nd CAS fixed - John@Z1 08:29:14 11/02/10
Post a Followup	You cannot reply to this message because you are not logged in.