Subject	There are plenty of opinions on ECU's, hoping to get some
Posted by	CoHPhasor on October 31, 2010 at 8:31 PM
	This message has been viewed 126 times.
Message	As some of you might already know, I'm installing the WinFactory rail with 1000cc Injector Dynamics injectors this week. I'm waiting on the injectors/spec sheet to come in, and then I'll call a vendor to order an EPROM. (have a JWT ECU now) I know there are tons of posts in search about ECU tunes in general, but I'm looking for info specific to these injectors. Injector Dynamics' big advantage is having matched sets and very specific/helpful flow sheets. I *need to have a tune so I can start the car and drive. I do however know the best thing to do would be to get the Z to a tuner and let them set it up from scratch. (vs paying for a "shelf-tune" that isn't fully tuned then later getting a dyno-tune) The question is, some vendors are better setup for 1000cc Injector Dynamics tunes than others? Have you had 1000cc ID's setup before? Let me know, thanks! (I'll likely get the specs tomorrow and setup an order then)
Follow Ups	There are plenty of opinions on ECU's, hoping to get some - CoHPhasor 20:31:09 10/31/10 JWT can get you a base tune for your injectors for $100. (n/m) - Bernie (NoVA) 22:03:17 10/31/10 Re: There are plenty of opinions on ECU's, hoping to get some - megaDan 07:33:03 11/01/10 I have programming specifically for those injectors already. - Ash's Z 08:02:17 11/01/10 Go with Ash ECU. (n/m) - Z-speed 19:47:55 11/01/10
Post a Followup	You cannot reply to this message because you are not logged in.