Subject	Seems pretty simple.
Posted by	Spddracer on October 13, 2010 at 7:18 PM
	This message has been viewed 97 times.
In Reply To	RPS Flywheel back to OEM posted by njz on October 13, 2010 at 06:18 PM
Message	Your segments are probably not level, You are under clutched, Any slippage and uneven plates will wear it out. Simple math says at #2,000 plate load and a organic disk works out to about 380TQ and with your mods you are more than likely pushing that limit pretty bad. www.Zspeedperformance.com
Follow Ups	RPS Flywheel back to OEM - njz 18:18:49 10/13/10 you replaced the segments without replacing the disk? (n/m) - KasbeKZ(VA) 18:36:02 10/13/10 No, replaced both clutch and flywheel plates on overhaul - njz 18:57:03 10/13/10 Seems pretty simple. - Spddracer 19:18:37 10/13/10 Re: Seems pretty simple. - njz 20:06:19 10/13/10 Is your exhaust setup 2.5"? (n/m) - 5280Z_nightstalker 00:53:00 10/14/10
Post a Followup	You cannot reply to this message because you are not logged in.