Subject	Re: need some advice
Posted by	CmyZ on October 07, 2010 at 1:53 PM
	This message has been viewed 68 times.
In Reply To	need some advice posted by Gustavo on October 06, 2010 at 08:35 PM
Message	You can switch the harness with the engine in, here is what to do. Pull the plenum, since you are doing injectors. Get inside the car and make sure you remove the shifter support, so it does not get damaged when you are lowering the cross member. Lift the car, lower the cross member and get to it. This will allow the engine to drop a couple of inches for you to have access, it won't be easy, but I have done it. My preferred way is to pull the engine. Naturally you will have to realign the car after. Good luck.
Follow Ups	need some advice - Gustavo 20:35:00 10/06/10 Since you mentioned Shiner Brews . - ArubaDave 21:00:50 10/06/10 Re: Since you mentioned Shiner Brews . - Gustavo 21:15:53 10/06/10 Yes it is. Shiner = awesomeness in a bottle. (n/m) - zfreak(Dallas) 21:49:02 10/06/10 Psssshhh. Move to the Northwest for a while. - Under_Powered 22:07:27 10/06/10 Get ahold of Guapo - Dallas DamonZ 23:10:36 10/06/10 Re: need some advice - CmyZ 13:53:11 10/07/10 Or you could skip the crossmember part. - Jehannum 16:16:28 10/08/10 Re: need some advice (n/m) - agregory 14:09:36 10/08/10 It will be difficult. - Jehannum 16:27:17 10/08/10
Post a Followup	You cannot reply to this message because you are not logged in.