Subject	BDE cam gear install question
Posted by	ae300z on October 06, 2010 at 10:43 PM
	This message has been viewed 223 times.
Message	I searched and couldn't find any thing about the BDE cam gear install on JWT 500 cams. I have the 90 - 93 cam gears I am installing. I used the 7mm spacer and longer dowel pin. I installed the gears and torqued to 90 ft/lbs, yet there is still about a 3mm gap between the cam gear and the end of the cam where the 7mm spacer is. Is this correct? Should not the gear mount flush to the cam spacer?
Follow Ups	BDE cam gear install question - ae300z 22:43:52 10/06/10 Just call Brett Dempsey - blackomega 10:27:42 10/07/10 No, that is not correct. Sounds like some foreign object is - LitlElvis 10:38:11 10/07/10 I feel like a goob, the gap I am seeing is the bevel on - ae300z 21:34:02 10/07/10
Post a Followup	You cannot reply to this message because you are not logged in.