Subject	You put that end in the hole?
Posted by	Spddracer on October 03, 2010 at 12:34 AM
	This message has been viewed 158 times.
In Reply To	Idler studs: Anyone have this happen? posted by BoneZ on October 02, 2010 at 11:59 PM
Message	Thats the "hole" problem, The other end or coarse threads go into the block for the lower and the intake for the upper. Fine threaded ends are for the nuts after you install the idlers back on. User error... Installed backwards. I just put them in my car today after my lower idler started to make noise and about cost me an engine yesterday, close call as my idler was hardly able to be turned by hand EEKKK! www.Zspeedperformance.com
Follow Ups	Idler studs: Anyone have this happen? - BoneZ 23:59:01 10/02/10 a classic cross-thread, no? (n/m) - KasbeKZ(VA) 00:11:31 10/03/10 It happened on my lower OEM stud. - rojoloco (San Diego) 00:12:46 10/03/10 You put that end in the hole? - Spddracer 00:34:49 10/03/10 That sounds incredibly scary. (n/m) - CoHPhasor 01:09:43 10/03/10 Oh, tikes! I thought the nut did that to him. - rojoloco (San Diego) 09:54:53 10/03/10 I should clarify - Spddracer 12:11:37 10/03/10 wow. If that end came out of the block - canyoncarver 07:24:15 10/03/10 Thanks fellas. Better safe than sorry. - BoneZ 15:48:23 10/03/10 you need to heilcoil the lower intake now. would not just - Dane (Houston) 12:56:59 10/03/10 Hey did you recieve my email? (n/m) - MikeVar82 18:29:18 10/03/10
Post a Followup	You cannot reply to this message because you are not logged in.