Subject	Now that iv polished the plenum , how do I clean the inside
Posted by	xteam300tt on September 26, 2010 at 1:11 PM
	This message has been viewed 731 times.
Message	During the plenum polishing I know i filled that thing up with sand , wire and polish particals . I plan on asking kyle @ IPP if they can port and gasket match the upper and lower plenums when they do my long block and if so it wouldnt make much since for me to clean it now . would it ? but if i do need to clean the inside of it , how ? and with what ? Any thoughts appreciated .
Follow Ups	Now that iv polished the plenum , how do I clean the inside - xteam300tt 13:11:57 09/26/10 Looks great! How long did it take you? (n/m) - Inconsistent Z 13:41:44 09/26/10 Re: Looks great! How long did it take you? - xteam300tt 13:49:54 09/26/10 can you post a link to the write up? - Figifister 14:20:25 09/26/10 link inside . - xteam300tt 15:21:57 09/26/10 Now that he's done with all the polishing - wouldn't the - jzack 17:01:36 09/26/10 yeah im not a expert either - Figifister 18:39:35 09/26/10 Im liking this idea . I'll see what's available around here - xteam300tt 22:31:07 09/26/10 Spray it out first, then get it dipped... - Jim (Selin Design) 02:44:46 09/27/10 I used a pressure washer... - Jim (Selin Design) 14:20:25 09/26/10 That looks great. I have often thought of doing something - Ziceman(East TN) 15:53:13 09/26/10 I used a cheap, cylindrical toilet brush with tons of dawn - zhundred3x 16:23:46 09/26/10 Did similiar with mine recently --but instead used spray - jzack 17:08:31 09/26/10 try a transmission rebuilder, they clean aluminum trans - LitlElvis 16:34:46 09/26/10 Hot tank? (n/m) - BigTDogg (MA) 16:35:49 09/26/10 x2 - Take it to a local machine shop and have them dunk it (n/m) - black300zx 16:42:56 09/26/10 ...then repolish it afterward. (n/m) - zfreak(Dallas) 09:25:27 09/27/10 It can't be cleaned. Send it to me & I will send you a - Boosted1 18:53:20 09/26/10 Re: It can't be cleaned. Send it to me & I will send you a - Zesus 20:35:24 09/26/10 lol! (n/m) - Inconsistent Z 08:17:30 09/27/10 pressure washer (n/m) - Dane (Houston) 01:00:58 09/27/10
Post a Followup	You cannot reply to this message because you are not logged in.