Subject	You can change the CHRA's yourself.
Posted by	MixManMash on September 21, 2010 at 1:57 PM
	This message has been viewed 152 times.
In Reply To	Question regarding CHRA's. posted by rojoloco (San Diego) on September 21, 2010 at 01:29 PM
Message	Honestly, if you are on a budget, get new CHRA's. They are only around $400 per CHRA. Otherwise, I would look for something similar to a JWT 530/500 or equivalent.. I've seen a few people around here selling used ones for around $1500. Of course, with this you are going to have to get the 5-bolt downpipes to add to your expenses.
Follow Ups	Question regarding CHRA's. - rojoloco (San Diego) 13:29:54 09/21/10 GT28R's are about the same price as sport 500's - ZXoltan 13:41:42 09/21/10 You can change the CHRA's yourself. - MixManMash 13:57:54 09/21/10 Sport 500's will use the same 4-bolt down pipes - Barry(TN) 14:01:38 09/21/10 If you can clock a turbo, you can replace the CHRA. - dogpile 14:26:55 09/21/10 someones selling 530s? Pray tell.. (n/m) - ZiNnYc 15:17:48 09/21/10 Search :-P - MixManMash 15:31:39 09/21/10 Step by step instructions are on Z1's site. - EricTTZ 14:38:51 09/21/10 Sexy Time! - rojoloco (San Diego) 20:13:17 09/21/10 You can do it yourself but certain tools are needed. - ZTicket(Dallas) 17:06:13 09/21/10 According to the write-up... - rojoloco (San Diego) 20:16:15 09/21/10 I just did this and it was a 'snap' - EricTTZ 21:40:58 09/21/10 That's way too expensive - ZXRider 03:23:48 09/22/10 2nd. - Woody75 (Denver) 08:29:27 09/22/10 That's what I meant. Snap ring not slip ring. lol - rojoloco (San Diego) 03:59:51 09/22/10 For $100 EPRacing will coat turbos and during the breakdown - CoHPhasor 02:01:38 09/22/10 I replaced the CHRAs on my turbos - ZXRider 03:26:20 09/22/10 Yeah, other than the plier set, I have all the tools. - rojoloco (San Diego) 04:01:25 09/22/10 PS Did you end up getting your plenum powder coated? - ZXRider 03:28:00 09/22/10 I actually purchased one from another guy. - rojoloco (San Diego) 04:02:16 09/22/10 Figured the money for powder coating could be used - ZXRider 04:07:24 09/22/10 Yeah, I managed to get one for $75 shipped. Not too shabby. - rojoloco (San Diego) 04:37:32 09/22/10 Yes just dump them in a metal bucket full of PB blaster - ZXRider 14:59:52 09/22/10 big 2nd on skipping engine dressup - ali300zx 08:30:16 09/22/10
Post a Followup	You cannot reply to this message because you are not logged in.