Subject	Sure it can be welded, but it's not worth it.
Posted by	LitlElvis on September 17, 2010 at 12:14 PM
	This message has been viewed 101 times.
In Reply To	a good shop can repair the head (n/m) posted by aliaZ on September 17, 2010 at 09:07 AM
Message	Especially since the OP only seems interested in how to maximize the amount of money he can get for the part. If I were looking to buy a head and that was all I could find, I'd be more concerned about "what" happened to cause the crack(s) and "how" it may have affected the rest of the head... finally, I'd wonder if it was even repaired properly. After all of the welded aluminum heads I've seen, there is no way I would buy a repaired head from anyone, there's too many "what ifs" that come with them and it's so easy to find good used replacement heads that are cheap. I estimate it would cost $200 in welding for it to be done correctly with prep and preheating - if you go with Tech@EPR's advice and replace all the guides and seats for just one cylinder, there's another easy $200 of parts and labor.
Follow Ups	Have a cracked cylinder head...recycle it? - ELDIABLO 08:43:24 09/17/10 a good shop can repair the head (n/m) - aliaZ 09:07:36 09/17/10 Sure it can be welded, but it's not worth it. - LitlElvis 12:14:48 09/17/10 whether or not it's worth it is subjective - aliaZ 13:10:43 09/17/10 Re: whether or not it's worth it is subjective - Tech@EPR 17:43:18 09/17/10 There was no extensive head work done. (n/m) - ELDIABLO 20:54:46 09/17/10 Detonation was the cause and I have already replaced that - ELDIABLO 20:54:15 09/17/10 Re: Have a cracked cylinder head...recycle it? - Tech@EPR 11:38:38 09/17/10
Post a Followup	You cannot reply to this message because you are not logged in.