Carlos,
The oil tubes are framed by the engine cover that goes across the back - not shown in the pictures I have posted. but it makes sense with the covers on.
The plenum is very shiny but is dirty and covered in silicon spray currently. The fan shroud will be made - I am leaving it until nearer the end as it will need to be a custom job and I don't want to do it twice. The contrast is provided by the engine skins and if you think I haven't looked at this thing from every angle in every light then you are smoking something illegal (in the UK anyway)! I have some room for a centre cover (over the rails) and I am playing with some ideas. Remember - engine skins and inner fenders in carbon (possibly), single piece flip front section which will only go so far up in the air... So... Now: the hood of the car is fully open and now imagine walking around the front of the car and seeing the engine from those new angles and new restrictions. It's going to work. Trust me! I have sweat buckets on the final look and not much is going to change now. I will remain focused and continue to have belief in my design goal moving forward. I will not be swayed by the Carlos ha ha lol Thanks for the comments as ever Carlos.
|
