Subject	Xactly how my deck lid was done & in 2 pieces>>>>
Posted by	ZUL8TR on September 11, 2010 at 4:37 PM
	This message has been viewed 86 times.
In Reply To	Lay tine on outside of glass, Overlap if you use 2 pieces posted by Spddracer on September 11, 2010 at 10:40 AM
Message	The double film cut joint was made along a heat strip line and after installation it is virtually invisable. ZUL8TR in Orlando,FL
Follow Ups	Tinting the hatch glass. What is the best way to tint the - DKaway 08:41:21 09/11/10 strips for the rear gkass - BoneZ 08:53:32 09/11/10 yes, but never a glass that large. so no experience with it - DKaway 10:11:19 09/11/10 I second Spddracer's post below. That's how I would - BoneZ 11:16:03 09/11/10 Have the seam of the 2 pieces along 1 of the defroster wires (n/m) - jschrauwen 09:11:50 09/11/10 take it to a pro, pay the $ 50 , problem solved (n/m) - hondahaters 09:35:54 09/11/10 can't take it to a pro because it will not cost $50. - DKaway 10:19:26 09/11/10 So there is where they went :-) - ArubaDave 10:01:26 09/12/10 2 large strips, steady hand and 2nd jschrauwen (n/m) - ZiNnYc 10:38:16 09/11/10 Lay tine on outside of glass, Overlap if you use 2 pieces - Spddracer 10:40:17 09/11/10 Xactly how my deck lid was done & in 2 pieces>>>> - ZUL8TR 16:37:56 09/11/10 Harder to do with 2 pieces but this is basically it - Spddracer 20:07:14 09/11/10 They sell tint specifically for that purpose - ZLover4Life 12:24:10 09/11/10 Those kits are alright, but the less joints the better. (n/m) - BoneZ 12:38:11 09/11/10 If you do it right - ZLover4Life 12:45:06 09/11/10 Are those old school Stillen GTZ wheels? (n/m) - Bernie (NoVA) 20:57:15 09/11/10 Yes they were. (n/m) - ZLover4Life 01:41:59 09/12/10 Werd. (n/m) - Bernie (NoVA) 20:13:26 09/12/10 What Hondahaters said. Any tint shop can do it in less then - Got a Birth certificate?? 22:51:07 09/11/10
Post a Followup	You cannot reply to this message because you are not logged in.