| Basically this is how its done. Clean inside of glass. Clean outside of glass Wet down outside of glass Lay film out on outside of glass making sure you have the glued side up but not separated yet. If you must use 2 pieces over lap the 2 pieces on the outside of the glass, Squeegee tint down to the glass,
With a sharp razor blade cut your tint to the exact size of the window, Cut directly across your overlap of the 2 pieces making one continuous cut through both pieces of film. This will give you a perfect fit on the inside, Just butt the 2 together when you go to install it. You may have to uise a heat gun when it is on the outside to stretch the film to the glass, Heat squeegee, heat squeegee ect.
www.Zspeedperformance.com |
