Subject	point is that it needs to be measurable, not just theory
Posted by	ztunerz on September 10, 2010 at 9:11 AM
	This message has been viewed 101 times.
In Reply To	Its only a very thin layer of paint (10 to 25 microns) posted by Pilot.P (NZ) on September 10, 2010 at 04:34 AM
Message	I know that surface temps of turbine housings drops 400 to 500 F when you ceramic coat the turbine housings, i verified it myself with a IR gun and have before and after readings. I also got EGT readings before and after. In other words i have data to back up what i just said. Mitch might be a nice guy however i never see any REAL data to back up what he says. Same goes for the oil pump porting which supposedly increases flow but there is no before and after measurement. I would have no issue with any of this but need numbers to back up the story. "Take these vitamins because they are good for you" does not really work for me. Harry Formerly yellowzxtt
Follow Ups	I have *got to say, this could be a super, sweet deal.. - CoHPhasor 17:58:29 09/09/10 Our turbos are already "Stealthy"... - zfreak(Dallas) 18:33:20 09/09/10 Thats what I was thinking when I saw the pics, I was like - Musashi Sword 18:51:59 09/09/10 Coating with what ? Snake oil ? (n/m) - ztunerz 18:44:10 09/09/10 Personally I think thermal barrier and dispersants work - Pilot.P (NZ) 21:44:16 09/09/10 Any idea how thermal dispersants actually work? - EUGENE 03:12:09 09/10/10 Its only a very thin layer of paint (10 to 25 microns) - Pilot.P (NZ) 04:34:19 09/10/10 point is that it needs to be measurable, not just theory - ztunerz 09:11:54 09/10/10 Fair enough Harry - Pilot.P (NZ) 19:51:15 09/10/10 agree 100% with everything you said (n/m) - aliaZ 00:02:19 09/11/10 Re: point is that it needs to be measurable, not just theory - Tech@EPR 12:50:36 09/11/10 Why do I want him tearing apart my NEW turbos? - The Hawk 21:20:41 09/09/10 Assuming the CHRA stays intact i see no harm in coating the - ztunerz 09:15:41 09/10/10 my valve-cover-gasket-oil-leak-covered-mounted-where - ali300zx 10:46:32 09/10/10
Post a Followup	You cannot reply to this message because you are not logged in.