Subject	Wheel+Tire Question
Posted by	darkmann on August 31, 2010 at 11:13 PM
	This message has been viewed 111 times.
Message	Not your typical fitment question. On the rear, I have 285-30 Sumitomo HTR Z III on a 18x10 +37 SSR Prof. SP1. I bought the Simis used with 95% thread for fitment test. The issue I have is that this tire does not have as thick a wheel protection "bulge" as the B'Stones at the front. As a result, it doesn't fully "envelope" the wheel - the rim sticks out just a tad from the edge of the tire and I don't like that look at all - too bling for me! Is it the tire or the wheels? I don't think I can fit anything wider without some structural changes. I do have a set of G'Year Eagle GSD3 to replace the Sumitomos and I have used that as an excuse to drive the car hard all summer. Any suggestions or opinions are welcome. Thanks.
Follow Ups	Wheel+Tire Question - darkmann 23:13:34 08/31/10 You can fit a 295 tire on a 10' wheel: - RAGTPZ 00:03:14 09/01/10 Re: You can fit a 295 tire on a 10' wheel: - darkmann 00:19:04 09/01/10 Hmm...not sure about the HICAS, my setup had an NA rear - RAGTPZ 00:27:14 09/01/10 Re: Hmm...not sure about the HICAS, my setup had an NA rear - darkmann 00:49:14 09/01/10 I run a 18x10 +50 with a 285 no issues with hicas (n/m) - SkiFly01 12:30:00 09/01/10 Re: I run a 18x10 +50 with a 285 no issues with hicas - darkmann 13:17:22 09/01/10 Must be a narrow 285, they do vary from mfg to mfg - BigTDogg (MA) 07:25:34 09/01/10 Re: Must be a narrow 285, they do vary from mfg to mfg - darkmann 13:19:07 09/01/10
Post a Followup	You cannot reply to this message because you are not logged in.