Subject	The low and midrange is fine
Posted by	ArticDragon192 on August 29, 2010 at 10:44 PM
	This message has been viewed 43 times.
In Reply To	Re: Oh, totally missed that posted by Kennymonster on August 29, 2010 at 06:43 PM
Message	It's the top end where the car started to struggle. In the earlier runs, it was pulling timing so I'm not exactly sure what was cause it to pull timing a bit. But there goes the idea that 3" piping causes a drastic loss in low end torque.
Follow Ups	Went to the dyno - ArticDragon192 23:51:57 08/28/10 My results... 197hp/179lb-ft on Dynojet - evan_aggie 00:15:52 08/29/10 Re: My results... 197hp/179lb-ft on Dynojet - ArticDragon192 00:25:20 08/29/10 I meant that I have stock headers. (n/m) - evan_aggie 08:25:30 08/29/10 Oh, totally missed that - ArticDragon192 12:23:02 08/29/10 Re: Oh, totally missed that - Kennymonster 18:43:20 08/29/10 The low and midrange is fine - ArticDragon192 22:44:09 08/29/10 Event picture - JUNz (?00)rwhp 15:07:54 08/29/10
Post a Followup	You cannot reply to this message because you are not logged in.