Subject	I would tape stuff off and try doing it mostly by hand,
Posted by	Z32TT-R on August 28, 2010 at 2:49 AM
	This message has been viewed 78 times.
In Reply To	plenum pulled, fuel rails out, can i pressure wash the... posted by coolron300 on August 27, 2010 at 10:38 PM
Message	water getting in the motor is a no no, take your time.
Follow Ups	plenum pulled, fuel rails out, can i pressure wash the... - coolron300 22:38:34 08/27/10 You will get water in the motor. STOP this will hurt. (n/m) - loco 23:16:18 08/27/10 agreed - 300redtt 23:22:18 08/27/10 ok thanks for the input, any cleaning suggestions? (n/m) - coolron300 23:24:42 08/27/10 Yea: don't do it. What's the point? (n/m) - zellamay 00:26:20 08/28/10 Vacuum up any loose dirt/debris, then simple green & a towel - 91Z32TT 02:42:36 08/28/10 2nd. Or used compressed air to blow out the loose stuff - ConVerTT 09:36:10 08/28/10 I would tape stuff off and try doing it mostly by hand, - Z32TT-R 02:49:05 08/28/10 You should crop your sig more and fix the bent wheel rim (n/m) - lazer(NV) 12:43:13 08/29/10 Absolutely not - Drk93TT 08:33:41 08/28/10 not cool, ron. (n/m) - Adam (NoVA) 13:30:36 08/28/10 good one (n/m) - blackomega 13:50:18 08/28/10 lol (n/m) - Josher 19:08:53 08/28/10 LOL.got one for RudeMoodZ ? (n/m) - ArubaDave 19:37:46 08/28/10 "Not cool, you attention seeking dipshit?" :) (n/m) - ZiNnYc 20:36:29 08/28/10 I thought that one was for you? (n/m) - Adam (NoVA) 18:57:13 08/29/10 oohhhhhhhhhhhhhh its on now <neck shake> (n/m) - ZiNnYc 19:01:03 08/29/10 Tape the holes and use a steam (not pressure) cleaner - BobbyT 19:15:04 08/28/10
Post a Followup	You cannot reply to this message because you are not logged in.