| Message |
alignment issue. Most people would not even bother to notice it; however, I am curious as to why the feathering is running with the tread pattern, instead of across the tread pattern. I can feel the feathering, but it does not photograph. Putting my hand into the wheel well and dragging it around over the top of the tire, from front to back, I can feel the high edges on the outer edge of each front tire. Reversing direction, doing it in the opposite direction, the feather feels smooth. Again, this is different from most feathers I am familiar with because it is not running across the width of the tire from inner to outer [or vise versa]; but rather the feather runs with the tire around its outer circumference, with the high edge pointing towards the front of the car. Running my hand across the tire from outside to inside [or vice versa] reveals no feathering. The camber is less than a degree negative, and the toe-in is just slightly less than zero. About an eighth inch toe-in.
_________________________________________________
|
 |
