Subject	>>>
Posted by	ztunerz on August 17, 2010 at 9:57 AM
	This message has been viewed 178 times.
In Reply To	Innovate wideband questions posted by Sleeper_TTZ(SeKy) on August 16, 2010 at 09:08 PM
Message	1 and 2 will give you readings that might not represent either bank. i'd say weld a bung on either bank and fit 2 O2 sensors with 2 lc1's and XD 16 gauges if you want both banks all the time OR 2 bungs, swap sensorsas needed. Ideally both banks should be very close. if not there is an issue and you need to locate it. Formerly yellowzxtt
Follow Ups	Innovate wideband questions - Sleeper_TTZ(SeKy) 21:08:15 08/16/10 Weld a bung on each pipe, try both, leave it on the leanest. (n/m) - just4kinks 21:58:07 08/16/10 Well it doesn't get me both banks but it does - Sleeper_TTZ(SeKy) 08:20:51 08/17/10 search, one side does run leaner - 300redtt 23:22:27 08/16/10 sorry just re-read - 300redtt 23:24:00 08/16/10 not necessarily - aliaZ 06:24:48 08/17/10 ideally not (n/m) - ztunerz 09:54:18 08/17/10 >>> - ztunerz 09:57:30 08/17/10 2nd - black&yellowttz 10:15:02 08/17/10 This is how I run also. Two lc1s, one g3 gauge and and a - ConVerTT 10:39:26 08/17/10
Post a Followup	You cannot reply to this message because you are not logged in.