Subject	x2 if the existing pins are free of corrosion (n/m)
Posted by	black300zx on August 10, 2010 at 7:23 PM
	This message has been viewed 103 times.
In Reply To	De-pin it if you have the patience posted by ZXRider on August 10, 2010 at 06:53 PM
Message
Follow Ups	Installing new coilpack connectors, whats the consensus? - LJZTT 16:54:52 08/10/10 Well, with injectors I know it's cut and solder - CoHPhasor 17:01:07 08/10/10 I soldered. - PennStateZ (VB) 17:01:55 08/10/10 I de-pinned the wires from the old plastic and put them into - MixManMash 17:05:13 08/10/10 ok, yeah it looks like I got the hang of separating the - LJZTT 17:09:09 08/10/10 there is a write-up done by Ash that it's easy to follow - Cap927(Boston) 20:15:29 08/10/10 I have the actual "6-headed" tool for this job - LJZTT 09:11:52 08/11/10 another thing I did while replacing injector connectors - Cap927(Boston) 09:47:03 08/11/10 I didn't think "overkill" was even part of your vocabulary. (n/m) - Eric(FL) 12:19:06 08/11/10 have you ever seen under the hood of a car, engine running - Cap927(Boston) 12:43:07 08/11/10 He knows what it is, but chooses to live in denial (n/m) - BigTDogg (MA) 15:25:43 08/11/10 Ditto. (n/m) - spicyZ 10:28:31 08/11/10 Solder w/pigtails . (n/m) - ArubaDave 17:06:33 08/10/10 De-pin it if you have the patience - ZXRider 18:53:05 08/10/10 x2 if the existing pins are free of corrosion (n/m) - black300zx 19:23:25 08/10/10 Depin if the wires are still good - Stadsport (PHX) 23:54:10 08/10/10 I break old ones apart to depin. - Woody75 (Denver) 07:40:53 08/11/10 Wuss. (n/m) - Bernie (NoVA) 07:49:00 08/11/10 Heh, I did the same. Work smarter not harder. (n/m) - spicyZ 10:33:07 08/11/10 i would wait to replace the whole harness. - ZiNnYc 07:53:51 08/11/10 not a sensible option in my particular case, but thanks for - LJZTT 09:18:07 08/11/10 ummm, actually... It was solicited... - Adam (NoVA) 10:14:58 08/11/10 weird, I only read option #1 and #2. Where was #3? - Cap927(Boston) 10:27:44 08/11/10 de-pin and do them one by one.. wire by wire... (n/m) - chris@boostpro.net 16:26:16 08/11/10 done...thx for boost leak checker too btw, arrived yesterday (n/m) - LJZTT 05:07:59 08/12/10
Post a Followup	You cannot reply to this message because you are not logged in.