Subject	oops
Posted by	aliaZ on July 29, 2010 at 1:16 PM
	This message has been viewed 177 times.
In Reply To	I don't recall the tensioner needing any adjustment posted by MrPulldown(Tahoe) on July 29, 2010 at 12:58 PM
Message	:Was there something more to this that I missed and should be concerned about? Yes, definitely. Your tensioner is probably adjusted incorrectly, which can lead to a slipped belt, or a broken idler stud I'm baffled that someone would perform such a task without consulting some sort of service manual or write-up. I assume you probably guessed at all of the bolt torque values too?
Follow Ups	3 blocks from home, idler pulley sheared clean off (n/m) - turboz32 01:44:32 07/29/10 Wow. That's pretty crazy. - pearlwhite94ttz 02:06:11 07/29/10 It's a common problem. - DVDBURN (MD) 02:35:14 07/29/10 Right answer, wrong vendor. Order from Kyle at IPP - pearl5 10:03:34 07/29/10 I think you have BDE and RameyZ mixed up. (n/m) - MixManMash 10:08:55 07/29/10 Yep, thank you for correcting me. (n/m) - pearl5 10:15:20 07/29/10 Re: Wow. That's pretty crazy. - wrxfl 08:13:12 07/29/10 probable cause? - aliaZ 08:34:00 07/29/10 assuming you are referring to the timing belt idler - spyhunterTT(nj) 05:55:28 07/29/10 agreed - aliaZ 07:48:25 07/29/10 RameyZ idler studs adds that extra piece of mind though. (n/m) - ZiNnYc 09:29:12 07/29/10 Awesome! Extra brain mass included w/ the RameyZ studs! FTW! (n/m) - evan_aggie 10:36:58 07/29/10 lol! Nice. - Z_Cherub 10:44:16 07/29/10 agreed (n/m) - aliaZ 12:44:02 07/29/10 Re: RameyZ idler studs adds that extra piece of mind though. - canyoncarver 08:42:51 07/30/10 Theyre chock full of magic (n/m) - ZiNnYc 09:30:02 07/30/10 although there was one idiot who shall remain - spyhunterTT(nj) 06:18:35 07/30/10 Antonio? (n/m) - aliaZ 09:11:41 07/30/10 you guys are ruthless (n/m) - ZiNnYc 09:29:12 07/30/10 True but... - DVDBURN (MD) 10:46:53 07/29/10 oops, forgot... - DVDBURN (MD) 10:50:26 07/29/10 I don't recall the tensioner needing any adjustment - MrPulldown(Tahoe) 12:58:41 07/29/10 oops - aliaZ 13:16:29 07/29/10 I remember now - MrPulldown(Tahoe) 16:09:42 07/29/10 Did you rotate it around like it says in step 47? (n/m) - Broke_as_**** 17:19:17 07/29/10 I have also seen that when putting the upper pulley on - Spddracer 21:29:42 07/29/10
Post a Followup	You cannot reply to this message because you are not logged in.