Subject	My new Defi Temperature guage over the factory temp guage
Posted by	ELDIABLO on July 17, 2010 at 7:58 PM
	This message has been viewed 434 times.
Message	My factory temperature gauge on my Z has been acting up. I really didn't want to install A-pillar guages so I decided to install it in the most stealth place I could think of. I think it turned out fairly well. When I am driving I don't even see the factory gauge anymore. Just what I wanted. One question: What temperature should I set the needle on the gauge to indicate when the engine temperature is at or near overheating?? Soy dios y soy el diablo
Follow Ups	My new Defi Temperature guage over the factory temp guage - ELDIABLO 19:58:32 07/17/10 umm. why didnt u just fix the problem? (n/m) - ZiNnYc 20:47:48 07/17/10 Fix what problem? get a new "stock" guage sensor? - Figifister 21:55:04 07/17/10 um yea. that problem. - ZiNnYc 01:37:03 07/18/10 Well... now it's a problem. - pearlwhite94ttz 01:39:56 07/18/10 I didn't want an A-pillar guage and my Blitz - ELDIABLO 13:41:13 07/18/10 I replaced the sensor. The gauge was faulty - ELDIABLO 13:35:55 07/18/10 Re: My new Defi Temperature guage over the factory temp guage - ouikikazz 21:03:11 07/17/10 I prefer it inside the cluster. Did you try cleaning the - zgene4 21:53:50 07/17/10 Yes. New Sensor. New Connector. (n/m) - ELDIABLO 13:37:01 07/18/10 Shoulda spent the money on some new jeans. (n/m) - PoweredbyZ 21:59:56 07/17/10 ONE pair of jeans. I rock "Rock" Jeans cause my knots - ELDIABLO 13:38:09 07/18/10 Good idea, looks outta place tho - JustinSCZ32 09:00:00 07/18/10 Tweed looks "out of place" too.... - zfreak(Dallas) 09:50:46 07/18/10 No. I drilled a small hole in the black plastic to run the - ELDIABLO 13:39:24 07/18/10
Post a Followup	You cannot reply to this message because you are not logged in.