| Message |
To be clear, these are 18x10 +44 with 285/30/18 on all fours. The fronts will not clear the third link without spacers, therefore it came with 10mm spacers up front effectively making them +34. I have Powertrix Coilovers, the fronts are bottomed out, as low as possible but I also have 1" preload on all springs. I want to say that I am lowered 1.25-1.5" all around. Also have 2* negative camber on the front, and 1.5* on the rear. The rears fit perfectly and don't look like it can rub on the fender in any possible way, it's actually just the right offset if you're going by the tt.net wheel fitment guide. The fronts however do rub on the L shaped fender liner in the wheel well right in the center when the wheel is turned all the way either way. I can't be 100% positive that it is rubbing because of the wheel/tire setup as my splash shields were well worn and sagging already. The fronts look much more aggressive than the fronts and come close to the fender, however, even at stock spec I don't think it will rub unless you have 0 camber. Hope this helps, if you have more questions go ahead!
 It's never "DONE", just finished enough to drive :-) (n/m) - BigTDogg (MA) 16:56:06 06/03/10 |
 |
