| so i'm looking to buy a aeromotive 13109 adjustable fpr, going with a dual pump setup...looking for this setup to hold me over through the summer and over the winter i'll overhaul the whole fuel system (new rails/injectors/ss lines) so trying to figure out how to run this with the stock lines for now...so doing some research im looking at 2x -6an oring fittings into a 5/16 fitting for the stock fuel lines?
1x -6an plug that should run correctly into the stock lines? then when im ready to go with ss lines i can just swap out the -6an oring fittings for direct -6an lines through the fuel system?
are the sizes correct cause i was reading about some people using -6an to 3/8 fittings?
|
