Subject	You mean the shorty is new?
Posted by	CoHPhasor on July 01, 2010 at 10:31 PM
	This message has been viewed 50 times.
In Reply To	Re: There is a metal sleeve that goes between them posted by d_flore on July 01, 2010 at 09:46 PM
Message	You see, he mentioned the sleeve because there is a sleeve that goes through both of them that the bolt for the linkage. *IF it were currently installed you would take the sleeve out, the poke them from inside with a screwdriver. (Through one, then putting the flathead's edge on the inner cylinder wall edge of the other bushing.) Should be relatively easy. Hell, even if you break them, who cares? You *are replacing them with Brass right? afaik, the brass are "press-in", so you might not be able to do it at home, not without a really, really good tip.
Follow Ups	How in the world do you remove the plastic bushings that - d_flore 21:21:37 07/01/10 There is a metal sleeve that goes between them - BigTDogg (MA) 21:42:42 07/01/10 Re: There is a metal sleeve that goes between them - d_flore 21:46:54 07/01/10 You mean the shorty is new? - CoHPhasor 22:31:30 07/01/10 Pic? Just gently tap the bronze ones in using - spicyZ 12:02:41 07/02/10 Leave in & Sleeve it, or not, but sleeve it. - ttz'in (NorCal) 02:38:37 07/02/10 What? (n/m) - John (MD) 08:47:00 07/02/10 I'm going to guess this: - Z_Cherub 09:54:11 07/02/10 he must work for 5zigen marketing dept (n/m) - LJZTT 13:51:14 07/02/10 lol, O for 2 (n/m) - ttz'in (NorCal) 19:44:04 07/02/10
Post a Followup	You cannot reply to this message because you are not logged in.