Subject	Ditto
Posted by	thejoneZ (Sacto, CA) on June 14, 2010 at 1:23 AM
	This message has been viewed 73 times.
In Reply To	Up through the shifter hole posted by Broke_as_**** on June 13, 2010 at 04:04 PM
Message	That's where my LC1s are ran
Follow Ups	How is your wideband sensor wire routed into the cabin? - SuparexTT 14:02:19 06/13/10 I've seen posted here that similar resuts can be attained - LJZTT 15:45:26 06/13/10 This is a generic vendor tune. Nothing is customized. (n/m) - SuparexTT 16:42:32 06/13/10 I routed mine via the hole behind the passenger rear.. - ForceFedTT (SoCal) 15:51:36 06/13/10 i have tried searching. i must stink at it :( (n/m) - SuparexTT 16:38:46 06/13/10 My setup - TTZ2NV(TX) 15:56:26 06/13/10 Up through the shifter hole - Broke_as_**** 16:04:25 06/13/10 Isn't running up by the shifter a weeee bit dangerous? (n/m) - SuparexTT 16:40:32 06/13/10 How? - Broke_as_**** 17:19:01 06/13/10 2nd - TTFairladyZ 18:40:37 06/13/10 3rd. Twice. And no it is not dangerous. - ConVerTT 19:35:21 06/13/10 Ditto - thejoneZ (Sacto, CA) 01:23:48 06/14/10 This is the spot. (n/m) - treese88 14:41:41 06/14/10 Also possible that ECUtalk is not configured correctly. - kkrofft (OH) 17:23:06 06/13/10 You think those #'s are bad? Highest I've had in 2 mos is 16 - CoHPhasor 19:02:11 06/13/10 too good to be true numbers. - SuparexTT 19:50:46 06/13/10 About 2 months ago... - Jehannum 10:48:26 06/14/10
Post a Followup	You cannot reply to this message because you are not logged in.