Subject	3rd. Twice. And no it is not dangerous.
Posted by	ConVerTT on June 13, 2010 at 7:35 PM
	This message has been viewed 49 times.
In Reply To	Up through the shifter hole posted by Broke_as_**** on June 13, 2010 at 04:04 PM
Message	The bracket keeps the wires to the right of the left of the tunnel and the heatshield keeps them out of the driveshaft.
Follow Ups	How is your wideband sensor wire routed into the cabin? - SuparexTT 14:02:19 06/13/10 I've seen posted here that similar resuts can be attained - LJZTT 15:45:26 06/13/10 This is a generic vendor tune. Nothing is customized. (n/m) - SuparexTT 16:42:32 06/13/10 I routed mine via the hole behind the passenger rear.. - ForceFedTT (SoCal) 15:51:36 06/13/10 i have tried searching. i must stink at it :( (n/m) - SuparexTT 16:38:46 06/13/10 My setup - TTZ2NV(TX) 15:56:26 06/13/10 Up through the shifter hole - Broke_as_**** 16:04:25 06/13/10 Isn't running up by the shifter a weeee bit dangerous? (n/m) - SuparexTT 16:40:32 06/13/10 How? - Broke_as_**** 17:19:01 06/13/10 2nd - TTFairladyZ 18:40:37 06/13/10 3rd. Twice. And no it is not dangerous. - ConVerTT 19:35:21 06/13/10 Ditto - thejoneZ (Sacto, CA) 01:23:48 06/14/10 This is the spot. (n/m) - treese88 14:41:41 06/14/10 Also possible that ECUtalk is not configured correctly. - kkrofft (OH) 17:23:06 06/13/10 You think those #'s are bad? Highest I've had in 2 mos is 16 - CoHPhasor 19:02:11 06/13/10 too good to be true numbers. - SuparexTT 19:50:46 06/13/10 About 2 months ago... - Jehannum 10:48:26 06/14/10
Post a Followup	You cannot reply to this message because you are not logged in.