Subject	How?
Posted by	Broke_as_**** on June 13, 2010 at 5:19 PM
	This message has been viewed 35 times.
In Reply To	Isn't running up by the shifter a weeee bit dangerous? (n/m) posted by SuparexTT on June 13, 2010 at 04:40 PM
Message	Zip tie the wires out of the way so they don't get caught behind the gear linkage and you're good. You'd have to really put some effort in to screw it up.
Follow Ups	How is your wideband sensor wire routed into the cabin? - SuparexTT 14:02:19 06/13/10 I've seen posted here that similar resuts can be attained - LJZTT 15:45:26 06/13/10 This is a generic vendor tune. Nothing is customized. (n/m) - SuparexTT 16:42:32 06/13/10 I routed mine via the hole behind the passenger rear.. - ForceFedTT (SoCal) 15:51:36 06/13/10 i have tried searching. i must stink at it :( (n/m) - SuparexTT 16:38:46 06/13/10 My setup - TTZ2NV(TX) 15:56:26 06/13/10 Up through the shifter hole - Broke_as_**** 16:04:25 06/13/10 Isn't running up by the shifter a weeee bit dangerous? (n/m) - SuparexTT 16:40:32 06/13/10 How? - Broke_as_**** 17:19:01 06/13/10 2nd - TTFairladyZ 18:40:37 06/13/10 3rd. Twice. And no it is not dangerous. - ConVerTT 19:35:21 06/13/10 Ditto - thejoneZ (Sacto, CA) 01:23:48 06/14/10 This is the spot. (n/m) - treese88 14:41:41 06/14/10 Also possible that ECUtalk is not configured correctly. - kkrofft (OH) 17:23:06 06/13/10 You think those #'s are bad? Highest I've had in 2 mos is 16 - CoHPhasor 19:02:11 06/13/10 too good to be true numbers. - SuparexTT 19:50:46 06/13/10 About 2 months ago... - Jehannum 10:48:26 06/14/10
Post a Followup	You cannot reply to this message because you are not logged in.