| fender liner. There's a hole behind that liner that is plugged with a rubber plug. From the hole you can access another hole in the chassis on the inside of the passenger compartment. This hole is located behind the carpet (IIRC) and is usually covered by a round vinyl sticker to cap the hole. This 2nd hole (inside the chassis) is about 6-8 inches from the outter hole (hole behind fender liner). I used a wire hanger to fish the 02 sensor wire from the 1st hole to the 2nd. From there, you can run your wire to whereever your gauge/controller is located in your cabin. I'm sure ther's a lot more members here that have more creative methods for routing their wideband wires; i just tried the method I thought was fastest and required the least effort. Also, try doing a search if you havent already. There's probably some posts about this, I'm sure. BTW, I left that rubber plug in that first hole so the hole remains sealed; however, I had to drill a hole for the wire the to slide through the plug; I also had to slit the rubber plug to the radius so that i could slide the wire in, because the connector end of the wire obviously wont fit through the small hole drilled through the center.
 |
