Subject	All you need is a string, a ruler, and remember that C=pi*D (n/m)
Posted by	boileralum on June 09, 2010 at 1:03 AM
	This message has been viewed 96 times.
In Reply To	Racing Hart Tracer hub centric center bore measurements? posted by Jkova300z on June 08, 2010 at 09:04 PM
Message
Follow Ups	Racing Hart Tracer hub centric center bore measurements? - Jkova300z 21:04:01 06/08/10 I think Racing Hart are 73.1mm...... - zx299 21:37:59 06/08/10 All you need is a string, a ruler, and remember that C=pi*D (n/m) - boileralum 01:03:35 06/09/10 Bore measurements are a diameter not a circumference. (n/m) - Eric(FL) 09:04:17 06/09/10 middle school geometry dude - boileralum 13:12:50 06/09/10
Post a Followup	You cannot reply to this message because you are not logged in.