Subject	my guess would be that manufacturing needed...
Posted by	aZinAZoo on June 28, 2001 at 10:03 AM
	This message has been viewed 10 times.
In Reply To	SZR - Question about rotors posted by Elguapo (Work) on June 28, 2001 at 09:58 AM
Message	a way to hold the rotors on until the calipers could installed, maybe the whole spindle/hub assembly is built in one place then installed on the car somewhere else. As for the phillips head, they're cheap, but you're right, allens would be MUCH nicer to service.
Follow Ups	SZR - Question about rotors - Elguapo (Work) 09:58:09 06/28/01 my guess would be that manufacturing needed... - aZinAZoo 10:03:35 06/28/01 one of the screws was *really* on there good>>>> - my91z(Got Clam?) 10:16:45 06/28/01 anytime man (n/m) - my91z(Got Clam?) 10:09:45 06/28/01
Post a Followup	You cannot reply to this message because you are not logged in.