Subject	2nd on cutting the sheetmetal for the plates
Posted by	TTFairladyZ on May 21, 2010 at 11:30 AM
	This message has been viewed 3 times.
In Reply To	posted by on {No date specified}
Message	But I used the old oval gaskets that were around the egr pipes as an outline. Same thing, just a little easier. 1990 Nissan 300ZXTT Stage III+ 11.96 e.t. 1.61 60ft on original stock turbos
Follow Ups	2nd on cutting the sheetmetal for the plates - TTFairladyZ 11:30:50 05/21/10
Post a Followup	You cannot reply to this message because you are not logged in.