Subject	Ok so Im sitting in my car right now
Posted by	blackomega on May 17, 2010 at 2:38 PM
	This message has been viewed 143 times.
Message	Trying to install my new head unit. Unfortunately the plug from theold unit doesn't fit my new unit so I have some wiring to do. Problem is that the wire colors coming up from the abyss don't match what the wire colors of the new unit are. Can any one tell me or link me to the factory speaker and stereo wire colors? I searched and got no results for some reason and scanned the faq but capabilities are limited from mobile phone... Thanks in advance ___________________ "If everybody is thinking alike, somebody isn't thinking." "Pressure makes diamonds." ~~ George S. Patton Blow money on your Z, it deserves it. It loves you.
Follow Ups	Ok so Im sitting in my car right now - blackomega 14:38:24 05/17/10 Re: Ok so Im sitting in my car right now - blackomega 14:42:43 05/17/10 Sounds like the previous system ran off an external amp. (n/m) - knerona 21:35:01 05/17/10 Don't splice into the factory harness, buy a harness adapter - just4kinks 14:44:54 05/17/10 factory harness was already cut - blackomega 14:47:00 05/17/10 From the AutoFAQ: - BigTDogg (MA) 14:53:17 05/17/10 Re: From the AutoFAQ: - blackomega 15:15:30 05/17/10 what happens if the wires from the joint harness are cut? (n/m) - blackomega 19:31:39 05/17/10 Nothing if you're not running the Bose amps, AFAIK (n/m) - BigTDogg (MA) 22:00:13 05/17/10 Good - blackomega 11:08:58 05/18/10 I would put the factory connector back on... - dpjax 14:58:36 05/17/10 I jsut spliced the new harness into the old. Pretty easy. - MrPulldown 15:21:47 05/17/10
Post a Followup	You cannot reply to this message because you are not logged in.