Subject	Hey I appreicate the offer! I will probably be doing it
Posted by	d_flore on May 16, 2010 at 2:34 PM
	This message has been viewed 50 times.
In Reply To	When are you doing this job. I'm in Calgary and I've done... posted by Black95 on May 16, 2010 at 01:55 AM
Message	within the next couple weeks. It is the last step before I get it out to the dyno and get her tuned!
Follow Ups	Swapping tranny soon. Any special tools I should have? - d_flore 17:07:40 05/15/10 get the car up as high as you can, and make sure you have - RDQ LUZ 17:13:42 05/15/10 One 20" extension works for me. (n/m) - Wright (Ca) 17:31:27 05/15/10 it works, but one more foot or so makes it even easier (n/m) - KasbeKZ(VA) 19:29:36 05/15/10 Thanks guys! (n/m) - d_flore 20:31:39 05/15/10 swivel/longextension/I also have a 14m wrench I cut in half - Paulym1111 18:37:12 05/15/10 Someone to help you - BlackTT91 19:06:24 05/15/10 All of my buddies say on the Z? Hell no there is no room - d_flore 20:30:43 05/15/10 it's not bad. the top two bolts might require skinny hands. (n/m) - SuparexTT 08:28:58 05/16/10 A transmission jack for sure! Three foot extension, and ... - Ziceman(East TN) 21:02:42 05/15/10 Re: A transmission jack for sure! Three foot extension, and ... - Ziceman(East TN) 08:03:52 05/16/10 No special tools needed - zstod 00:19:17 05/16/10 Nixit blocks are the shizzle for a trans job. (n/m) - ShakaShaun(Denver) 01:21:17 05/16/10 When are you doing this job. I'm in Calgary and I've done... - Black95 01:55:45 05/16/10 Hey I appreicate the offer! I will probably be doing it - d_flore 14:34:14 05/16/10 Who is tuning it? (n/m) - Black95 22:54:20 05/16/10 Re: Swapping tranny soon. Any special tools I should have? - CmyZ 09:20:34 05/16/10 The allen wrench / hex-keys that have the angled/ball ends - LJZTT 17:38:49 05/16/10 He's got an NA rear end, which IMO/IME is harder - BigTDogg (MA) 16:52:29 05/18/10
Post a Followup	You cannot reply to this message because you are not logged in.