Subject	Nixit blocks are the shizzle for a trans job. (n/m)
Posted by	ShakaShaun(Denver) on May 16, 2010 at 1:21 AM
	This message has been viewed 70 times.
In Reply To	Swapping tranny soon. Any special tools I should have? posted by d_flore on May 15, 2010 at 05:07 PM
Message
Follow Ups	Swapping tranny soon. Any special tools I should have? - d_flore 17:07:40 05/15/10 get the car up as high as you can, and make sure you have - RDQ LUZ 17:13:42 05/15/10 One 20" extension works for me. (n/m) - Wright (Ca) 17:31:27 05/15/10 it works, but one more foot or so makes it even easier (n/m) - KasbeKZ(VA) 19:29:36 05/15/10 Thanks guys! (n/m) - d_flore 20:31:39 05/15/10 swivel/longextension/I also have a 14m wrench I cut in half - Paulym1111 18:37:12 05/15/10 Someone to help you - BlackTT91 19:06:24 05/15/10 All of my buddies say on the Z? Hell no there is no room - d_flore 20:30:43 05/15/10 it's not bad. the top two bolts might require skinny hands. (n/m) - SuparexTT 08:28:58 05/16/10 A transmission jack for sure! Three foot extension, and ... - Ziceman(East TN) 21:02:42 05/15/10 Re: A transmission jack for sure! Three foot extension, and ... - Ziceman(East TN) 08:03:52 05/16/10 No special tools needed - zstod 00:19:17 05/16/10 Nixit blocks are the shizzle for a trans job. (n/m) - ShakaShaun(Denver) 01:21:17 05/16/10 When are you doing this job. I'm in Calgary and I've done... - Black95 01:55:45 05/16/10 Hey I appreicate the offer! I will probably be doing it - d_flore 14:34:14 05/16/10 Who is tuning it? (n/m) - Black95 22:54:20 05/16/10 Re: Swapping tranny soon. Any special tools I should have? - CmyZ 09:20:34 05/16/10 The allen wrench / hex-keys that have the angled/ball ends - LJZTT 17:38:49 05/16/10 He's got an NA rear end, which IMO/IME is harder - BigTDogg (MA) 16:52:29 05/18/10
Post a Followup	You cannot reply to this message because you are not logged in.