TwinTurbo.NET: Nissan 300ZX forum - All of my buddies say on the Z? Hell no there is no room
Subject
All of my buddies say on the Z? Hell no there is no room
Posted by
d_flore
on May 15, 2010 at 8:30 PM
This message has been viewed
39
times.
In Reply To
Someone to help you
posted by BlackTT91
on May 15, 2010 at 07:06 PM
Message
to do anything. Lol
Follow Ups
Swapping tranny soon. Any special tools I should have?
-
d_flore
17:07:40 05/15/10
get the car up as high as you can, and make sure you have
-
RDQ LUZ
17:13:42 05/15/10
One 20" extension works for me. (n/m)
-
Wright (Ca)
17:31:27 05/15/10
it works, but one more foot or so makes it even easier (n/m)
-
KasbeKZ(VA)
19:29:36 05/15/10
Thanks guys! (n/m)
-
d_flore
20:31:39 05/15/10
swivel/longextension/I also have a 14m wrench I cut in half
-
Paulym1111
18:37:12 05/15/10
Someone to help you
-
BlackTT91
19:06:24 05/15/10
All of my buddies say on the Z? Hell no there is no room -
d_flore
20:30:43 05/15/10
it's not bad. the top two bolts might require skinny hands. (n/m)
-
SuparexTT
08:28:58 05/16/10
A transmission jack for sure! Three foot extension, and ...
-
Ziceman(East TN)
21:02:42 05/15/10
Re: A transmission jack for sure! Three foot extension, and ...
-
Ziceman(East TN)
08:03:52 05/16/10
No special tools needed
-
zstod
00:19:17 05/16/10
Nixit blocks are the shizzle for a trans job. (n/m)
-
ShakaShaun(Denver)
01:21:17 05/16/10
When are you doing this job. I'm in Calgary and I've done...
-
Black95
01:55:45 05/16/10
Hey I appreicate the offer! I will probably be doing it
-
d_flore
14:34:14 05/16/10
Who is tuning it? (n/m)
-
Black95
22:54:20 05/16/10
Re: Swapping tranny soon. Any special tools I should have?
-
CmyZ
09:20:34 05/16/10
The allen wrench / hex-keys that have the angled/ball ends
-
LJZTT
17:38:49 05/16/10
He's got an NA rear end, which IMO/IME is harder
-
BigTDogg (MA)
16:52:29 05/18/10
Post a
Followup
You cannot reply to this message because you are not
logged in
.