TwinTurbo.NET: Nissan 300ZX forum - Selin Dual MAF Setup - just completed installaton.
People Seeking Info
 
   


     
Subject Selin Dual MAF Setup - just completed installaton.
     
Posted by 91z tt on May 08, 2010 at 8:37 AM
  This message has been viewed 412 times.
     
     
Message Long story, short; I was skeptical when I installed this a few hours ago. All I can say is WHAT A DIFFERENCE!!! Easily one of the best mods due to it's bolt on simplicity. I had to remove the brace for my oil cooler (Nismo), even with that, it's still a tight fit. Install time ~ 40 minutes. The (my) kit came already set to "ADD". Be sure to fit the passenger side first, make life WAY easier. Also, be sure to have someWindex handy. it allows youto fit the elbows with minimum issues. After installation and upon initial startup, I noticed my idle was hunting. After a few pulls and a quick cruise on the NJ Turnpike - all was settled. Overall, the engine runs better, response is MUCH quicker througout the ENTIRE range. If you have the cash, GET THIS. if you don't, work some overtime or pick up a second gig for a while. As more find out about this, I can see it being on "backorder" in the very near future. You will not be dissappointed.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.