Subject	Couldnt find in "search" so I did it anyway.
Posted by	xteam300tt on April 26, 2010 at 12:48 PM
	This message has been viewed 676 times.
Message	In an attempt to further clean up my engine bay before engine installation i wanted to get rid of a few wires hangin around my d.side firewall ( wiper motor wiring, break fluid level wiring ect . ) and thought id share . This may have been done before but a search returned nothing . First i had to borrow some wiring harness and plugs from my donor z to extend my wiper motor and break fluid level wires Soilder , crimp ,heat shrink , tape, loom ,tape wiper wires were extended 14 inches. Then run on the inside and tie straped up away from the wiper arms out the drain and straped high away from drainage next i cut and extended the break fluid wiring and ran it through the fender all holes were painted and groumets inserted. Final pics VVVV And yes I know there are bolts loose and things out of place for now , but try to focus on the wire tuck :) Thanx
Follow Ups	Couldnt find in "search" so I did it anyway. - xteam300tt 12:48:00 04/26/10 Looks good. Did you re-locate the relay box also? - Wright (Ca) 13:23:03 04/26/10 Yes that was the easy part . I just pulled the plug - xteam300tt 14:11:22 04/26/10 Looks nice. Look forward to completed engine bay pics! (n/m) - Z_Cherub 13:25:12 04/26/10 Very Clean. (n/m) - toykoz32 14:09:45 04/26/10 Very nice. What did you do with the wiper amp? - BCs300z 14:14:49 04/26/10 I pulled it through and mounted it on the other side. - xteam300tt 14:31:44 04/26/10 Re: Couldnt find in "search" so I did it anyway. - Gixxer 15:45:46 04/26/10
Post a Followup	You cannot reply to this message because you are not logged in.