Subject	Didnt think about that . . Good point
Posted by	toykoz32 on April 23, 2010 at 6:23 PM
	This message has been viewed 87 times.
In Reply To	It's been a while since I took fluid dynamics but I wouldn't posted by Dave N on April 23, 2010 at 06:08 PM
Message	How much of the oil pan is filled with oil? 1/2, 2/3 ?
Follow Ups	Has anyone done/seen this? Good/Bad idea - toykoz32 17:57:34 04/23/10 Side photo - toykoz32 18:03:56 04/23/10 It's been a while since I took fluid dynamics but I wouldn't - Dave N 18:08:13 04/23/10 Didnt think about that . . Good point - toykoz32 18:23:16 04/23/10 Re: Didnt think about that . . Good point - CmyZ 00:26:50 04/24/10 Re: It's been a while since I took fluid dynamics but I wouldn't - CmyZ 00:24:35 04/24/10 Or they had a dented pan and this was the easier fix (LOL)?? (n/m) - jzack 08:56:23 04/24/10 Use a good non-modified oil pick-up strainer and gasket - RevTech 00:03:29 04/25/10 Not to thread jack, but what machine work did you get done? - ZaXxon 18:41:18 04/23/10 Re: Not to thread jack, but what machine work did you get done? - toykoz32 18:53:30 04/23/10 Great info, thanks. A couple more questions...... - ZaXxon 19:01:18 04/23/10 Re: Great info, thanks. A couple more questions...... - toykoz32 19:11:43 04/23/10 Did they use the new bearings when balancing the rotating... - ZaXxon 19:44:13 04/23/10 I really dont know the answer to that one. (n/m) - toykoz32 19:58:10 04/23/10
Post a Followup	You cannot reply to this message because you are not logged in.