Subject	Good ol' Harbor Freight
Posted by	91TurboZ on April 22, 2010 at 7:52 AM
	This message has been viewed 236 times.
In Reply To	engine lift to stand - harbor freight 1000lb bolt info posted by evan_aggie on April 21, 2010 at 11:42 PM
Message	Good info. I recently purchased a 1000lb Harbor Freight stand myself and like you I found that the bolts recommended in the past were too long. Interestingly, my friend had the same engine stand (his was purchased a year ago) and the stand-offs on the stand to engine mounting arms were longer than on the one I picked up.
Follow Ups	engine lift to stand - harbor freight 1000lb bolt info - evan_aggie 23:42:23 04/21/10 I have two different brand stands.. and one of them - KongZTT GT28RS MD 23:49:28 04/21/10 Also, I did use washers if the botl was too long.. - KongZTT GT28RS MD 23:54:47 04/21/10 Good ol' Harbor Freight - 91TurboZ 07:52:08 04/22/10 That's why I recommended measuring the arm length and - Wright (Ca) 09:14:02 04/22/10
Post a Followup	You cannot reply to this message because you are not logged in.