Subject	I have two different brand stands.. and one of them
Posted by	KongZTT GT28RS MD on April 21, 2010 at 11:49 PM
	This message has been viewed 258 times.
In Reply To	engine lift to stand - harbor freight 1000lb bolt info posted by evan_aggie on April 21, 2010 at 11:42 PM
Message	I use my Plenum bolts.. I have held the motor fully assembled with all turbos etc etc etc.. and even moved the engine stand around with the engine on stand and never had any problems.. I think my "rods" on the engine stand (that the bolts go through).. were about 3" long.. NO, This picture is not photoshopped. It took many times to take this picture. Setting up the timer, shutter speed etc, then jumping on my bike and getting the tire to spin. MySpace for those who have em' AIM:Shawn300zxTT "-Any closeups on the nuts? - zboost(tx) 19:17:53 08/08/05 -Not really something you want to ask another man about... (n/m) - LordZ 19:24:00 08/08/05" "I just took 45 min and scrubbed the heck out of my rear" teambushido(San Diego, CA) 19:24:51 12/11/04 -1991 Stage _ TT 5spd (Upgraded to hell and back) -1990 Super White 2+2 Na Stage 3 Auto (Daily Driver, contemplating selling.. ) -1990 Cherry Red Pearl ,Auto Coupe (Parts car) -1990 11 Sec Eagle Talon Tsi AWD, (SOLD!) -1996 Hyundai Sonata (Given to me for FREE , due to broken timing belt,bent valves.. fixed it myself and its my new DD that gets over 25 mpg! -2004 Honda CBR 600RR (Candy blue, FOR SALE)
Follow Ups	engine lift to stand - harbor freight 1000lb bolt info - evan_aggie 23:42:23 04/21/10 I have two different brand stands.. and one of them - KongZTT GT28RS MD 23:49:28 04/21/10 Also, I did use washers if the botl was too long.. - KongZTT GT28RS MD 23:54:47 04/21/10 Good ol' Harbor Freight - 91TurboZ 07:52:08 04/22/10 That's why I recommended measuring the arm length and - Wright (Ca) 09:14:02 04/22/10
Post a Followup	You cannot reply to this message because you are not logged in.