Subject	Thats a tight fit! Looks good though
Posted by	pearlwhite94ttz on April 17, 2010 at 7:35 PM
	This message has been viewed 430 times.
In Reply To	Conversion - Z1 DoolZ to Z1 Dual Intake posted by jschrauwen on April 17, 2010 at 05:01 PM
Message	Any plans to run dual metered intakes? I see that you have two MAF's, but I am guessing that one is a dummy? Does the Z1 kit not allow space to use the popchargers, or is it a fitment issue with everything else you managed to get into that space? If it's a Z1 issue, someone should point it out and have it corrected as the popchargers offer a generous amount of surface area when compared to the other intakes available. Very nice job though!
Follow Ups	Conversion - Z1 DoolZ to Z1 Dual Intake - jschrauwen 17:01:03 04/17/10 nice - ali300zx 17:21:04 04/17/10 Believe me Ali, I tried. - jschrauwen 17:57:43 04/17/10 Yeah, I had to move the oil cooler back a notch to fit mine (n/m) - KevinZtwin 20:27:39 04/17/10 Mine is already back a notch as well. (n/m) - jschrauwen 22:09:32 04/17/10 looking good (n/m) - moxie (SF) 18:43:14 04/17/10 Thats a tight fit! Looks good though - pearlwhite94ttz 19:35:02 04/17/10 I managed to fit mine... - thejoneZ (Sacto, CA) 20:19:14 04/17/10 It was - jschrauwen 20:26:34 04/17/10 nice...same thoughts...different outcome.. - zdoc 20:17:15 04/17/10 A little of both I guess, - jschrauwen 22:17:12 04/17/10 If I may, have a suggestion... - KongZTT GT28RS MD 06:12:33 04/18/10 Or I guess you could use some 45^ couplers to space - KongZTT GT28RS MD 06:19:54 04/18/10 Any issues with rpms dropping dangerously low .... - jschrauwen 09:57:59 04/18/10 Yep.. I had to use the DEC-AIR setting on my AFC - KongZTT GT28RS MD 17:01:04 04/18/10 Excellent suggestion sir!!! - jschrauwen 09:49:40 04/18/10 I'll take those flower pots off your hands, lemme know how - LJZTT 11:09:50 04/19/10
Post a Followup	You cannot reply to this message because you are not logged in.