Subject	nice.. Looks like you've done some great work! (n/m)
Posted by	KongZTT GT28RS MD on April 16, 2010 at 3:26 PM
	This message has been viewed 77 times.
In Reply To	I used carbide bits. posted by Sum0n3 on April 16, 2010 at 12:03 AM
Message
Follow Ups	My project so far.. - Sum0n3 04:32:42 04/15/10 Very Nice (n/m) - toykoz32 04:40:37 04/15/10 I tried to keep the budget in check.. - Sum0n3 12:58:36 04/15/10 sweet, someday I hope I have the know-how and experience - LJZTT 05:01:30 04/15/10 Thanks! - Sum0n3 05:06:31 04/15/10 smooth. looks like fun. (n/m) - eazyez 05:25:41 04/15/10 Very nice. - Boosted1 06:03:18 04/15/10 looks great!! im always paranoid about putting main studs in - fst300zx 06:07:26 04/15/10 Yooooo....whatup luke! When you opening back up? (n/m) - ZiNnYc 06:23:10 04/15/10 Looking Sharp! (n/m) - Ash's Z 07:51:09 04/15/10 You should benefit a lot from that port work. (n/m) - Turnerscasa (Dallas) 08:00:35 04/15/10 i like it!! (n/m) - 1badz32 (MN) 08:08:39 04/15/10 Looks great! - zfreak(Dallas) 09:50:18 04/15/10 Nice work!! (n/m) - Josef(Houston) 10:49:31 04/15/10 Fantastic. I wish I had the space for this - there is - 300NASeattle 12:05:26 04/15/10 I tried to keep the budget in check - Sum0n3 13:00:48 04/15/10 cool...well I needed it on the lift to check the - ZiNnYc 14:41:02 04/15/10 Nice!.. What did you use to do the port work? - KongZTT GT28RS MD 18:05:11 04/15/10 I used carbide bits. - Sum0n3 00:03:05 04/16/10 nice.. Looks like you've done some great work! (n/m) - KongZTT GT28RS MD 15:26:23 04/16/10 Thanks for sharing all this! (n/m) - BoneZ 20:26:17 04/15/10 looks great! I applaud you for such an endevour.... - Ghozt 22:12:26 04/15/10 Thanks for the interest guys! (n/m) - Sum0n3 00:04:28 04/16/10 Nice work! (n/m) - Turbodog (CT) 07:03:18 04/16/10 Looking good. (n/m) - Cuis-Z 09:08:01 04/16/10 Those are some clean internals. Quite lovely. (n/m) - schuss 12:29:32 04/16/10
Post a Followup	You cannot reply to this message because you are not logged in.